Windows 10: Wifi connects for exactly 2 minutes then disconnects

troubleshoot says my security types dont match so i fix it but when i reconnect the cycle starts again. Ive already checked my drivers, forgotten and reconnected to my wifi and reset my network. Anything will help as this issue only happens on my desktop!

:)

 

my son laptiop wifi disconnect after 5 minutes

• If you have an identical laptop try comparing the wifi and security settings of the one that does not disconnect with the one that does. If you find any differences change the settings of the one that does not work to the one that does.

• If you do not have an identical laptop see this post and the three replies for possible solutions: Wifi disconnects every 5 minutes.

@Samuria : If you have any suggestions please reply.

 

WiFi not automatically disconnecting when out of range

Gunnart,

I had a similar refusal to disconnect from a WiFi profile and I solved it.
- In my particular case, the unwanted network was still in range so I cannot say for certain that my symptoms were exactly the same as yours but they were certainly consistent with yours.
- The solution is not a destructive one so I do suggest you try it.

1 I turned WiFi off then repeated the fairly standard step of removing existing WiFi profiles - Settings, Networks, WiFi, Manage known networks, <select each one in turn>, Forget. Arguably, I could have just done this for the problem network but I was probably not thinking straight at the time.

2 I then opened RegEdit, went to
HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\Windows NT\CurrentVersion\NetworkList\Profiles
and deleted every subkey that referred to a WiFi network profile. Again, arguably, I could just have deleted all those that referred to the problem network.

3 I then turned WiFi back on and started from scratch detecting then connecting to the networks I wanted to use. There has been no repetition of the problem.

Some further commentary
A I had changed my internet connection device but had re-used the same network name on the new one.
B There were no strange entries in the list in Settings [step 1 above] & I quite wrongly thought that forgetting them represented a complete clearout.
C When I looked the Registry key [my step 2 above], I found that there were two subkeys with the relevant network name in the Description line.
- In one case, the same network name was repeated in the ProfileName line
- But the other entry contained a Profilename entry that had the expected network name with a suffix [2] after it.
- So my re-use of the name had been identified by Windows after all [I had just been trying to reduce the number of changes I had to work through when I swapped devices and had not thought there could be side-effects].


Best of luck,
Denis

 

Bridging wifi and ethernet connections – wifi keeps disconnecting

Hi all,

I am trying to use Windows to bridge my wifi connection to non wifi devices. I have successfully setup the bridge in Network Connections. However, the wifi only stays connected for a few seconds before it disconnects (everything is working as expected, with wired devices having internet access, until wifi disconnects). This seems to be something to do with the ethernet cable being connected, as when I disconnect the ethernet the wifi stays connected.

Things I have tried:

• Turning off power management and checking bios for any funky power management settings
  
• Setting "Priority & VLAN" to disabled
  
• Disabling "Automatic metic" and setting wifi to priority order – though you don't seem to be able to change this for specific connections when bridged.
  

Any suggestions greatly appreciated.

P.S. everything works fine with bridge disabled and using internet connection sharing enabled on the wifi. However I am unable to connect to devices such as printers (hence why I am trying bridged mode).