Windows 10: What is the best configuration for an older hp amd for a static ip without using any kind...

Hp notebook AMD energy star 15 is what the machine isA work station retired I believe. Lol.Im trying to speed it up. It's very slow and glichy sometimes.I may have gotten the wrong ram sticks in though. I have to do some reading on that cuz after upgrading from 3G to 16G the computer seems slower so I need to check into that very soon...Any helpful tip and or tricks may be helpful.Im not real sure how much better I expect the computer to get because it should really needs to be recycled or something. Lol. But it's all I have at the moment.So any configurations that would be a benefit to this t

:)

 

Static IP on Lumia 950.

Hi,

Follow the steps below and check if the features to apply static IP is available in your device.

• Navigate to settings.
• Search or navigate to “Wi-Fi”.
• Scroll all the way down and tap “static ip”.
• Turn on “Configure network settings manually”.
• Key in the IP address, subnet mask and other details

Note: Do remember that your router / DHCP should support allocating static IP for this feature to work.

If the above feature is not available then your model may not support the same.

Hope this helps

Regards

 

Static IP With Windows 10 and HP Zbook

Thanks for the suggestion but I'm not connecting to a router. I'm hard wired to a modem device that does not have DHCP so I need a static ip to set my IP address to the correct subnet. It works on another machine doing the exact same steps.

In my question I already checked ipconfig and it shows the correct ip/netmask on the dell machine that works and the HP that does not.

 

Static IP With Windows 10 and HP Zbook

I'm at my wits end with a problem that I see on my zbook with static ip addresses

To connect to a device, I need to set my ip to a 192.168.1.*, netmask 255.255.255.0 and gateway to 192.168.0.1. I do this by going to change adapter settings->properties(of Ethernet adapter) . Then click "Internet Protocol Version 4" and hit "properties.
This allows you to set a static IP. But the problem is I cannot connect to a device (DHCP is not available). I disabled all other adapters

I would think I'm doing something wrong with the setup except that following these exact steps with a DELL m6800 and it works fine! The only difference is HP is windows 10 and the DELL is windows 7. They are the same Intel I217-LM though.

Things I've tried:

1. Right click on adapter->Diagnose: I tried all suggestions until it tells me "gateway is not available"

2. Updating driver

3. Downloading hp driver

4. Checked ipconfig to verify correct ip set.

Any suggestions would be fantastic.

(I tried to post this on the HP support website but it is garbage and a nightmare to use)

PS anyone want to buy a zbook?