Windows 10: Stop the service OneApp.IGCC.WinService

Hi Guys

Re OneApp.IGCC.WinService
I like to stop this Service because its blocking my port80.
My question: Does it cause any major/minor problems if I stop this service, temporary or permently on Intel Corei7?

Claus

:)

 

Printing stopped with November upgrade

Hey Prestonpdx,

I would suggest you check if the print spooler is running. Start/Stop print spooler service. Follow the steps below.

• 
  Press Windows key + R, type services.msc
  and press Enter.
  
• 
  From the list, locate Print Spooler service.
  
• 
  Double click on the service and select Stop.
  
• 
  Restart the computer, repeat step 1&2.
  
• 
  Double click on the service and check if the service is started.
  

Get back to us with the updated status, we’ll be glad to assist you.

Thank you.

 

Windows Update - Service registration is missing or corrupt

Hi Nitya,

Upon analyzing the details and the troubleshooting steps you have done so far, we suggest that you
manually reset your Windows Update Components
by following these
troubleshooting steps:

• 
  Run
  Command Prompt as Administrator
  
• 
  Stop
  BITS, Cryptographic, MSI Installer and Windows Update Services. To do this,
  type the following command:
  
  • 
    Net stop wuauserv
    
  • 
    Net stop cryptSvc
    
  • 
    Net stop bits
    
  • 
    Net stop msiserver
    
• 
  Rename
  SoftwareDistribution
  and
  Catroot2
  folder. To do this, type the following commands:
  
  • 
    Ren C:\Windows\SoftwareDistribution SoftwareDistribution.old
    
  • 
    Ren C:\Windows\System32\catroot2 Catroot2.old
    
• 
  Restart
  BITS, Cryptographic, MSI Installer and Windows Update Services. To do this,
  type the following command:
  
  • 
    Net start wuauserv
    
  • 
    Net start cryptSvc
    
  • 
    Net start bits
    
  • 
    Net start msiserver
    
• 
  Restart
  your computer and try to
  install Windows Update.
  

Update us on how it goes.

Regards

 

Printer Spooler Service stops after upgrading to Windows 10

Hi,

Thank you for your response.

I suggest you to follow the steps below and check if it helps.

• Press Windows key + letter 'R.'
• Type "Services.msc" and hit OK.
• Locate "Print Spooler" service.
• Right click and select properties.
• Stop the service.
• Go to the "Recovery tab."
• Set the "First Failure" and "Second Failure" to "Restart the Service."
• From the Dependencies tab, ensure that RPC is turned on.
• Apply changes.
• Delete all the Print Job from C:\Windows\System32\Spool\Printers.
• Press Windows key + letter 'R.'
• Type "Services.msc" and hit OK.
• Locate "Print Spooler" service.
• Right click and select properties.
• Start the service.
• Apply changes and hit OK.

Hope this helps. Please reply for further queries on this.