Windows 10: SSD Boot Drive scanning issues.

Hello, for the last few weeks I've had an issue with my ssd when turning on my pc where it says 'press any button to skip scan' and I have looked into it and used CMD prompts such as;-sfc /scannow-chkdsk-chkdsk c: /f /r probably a few more but I've been at it for hours so I'm not sure anymore Yet nothing seems to be working, I've tried them through cmd console in windows as well as in the troubleshoot section on bootup. I really don't know what to do because Windows states the disk is not dirty and I am struggling to figure out what it could be.Any help would be appreciated :

:)

 

Random Disappearing/Reappearing SSD on Boot

Config:

ASUS P8Z68-V Pro/Gen 3
OWC Mercury Extreme Pro 6G 480GB SSD
Corsair 850W PSU
2x HD 6950 GPU's

My desktop has a 480GB SSD main drive (OS and games), and two secondary HDD's for media storage.

I have had no issues with this SSD, until I tried to add a second video card to my system, and subsequently had to remove it. After a couple re-installs and finally getting the Crossfire to work, I am still in this broken state.

Symptom:

If I put my computer to sleep, restart, power down, it is a complete gamble as to whether or not the system will see the boot drive. What is consistent, is that after a seemingly random interval, it will eventually see the drive and boot straight to windows.

Troubleshooting Steps:

• Reset Bios
• Removed all other options for bootable devices
• Re-installed Windows
• Updated all OS drivers
• Updated firmware for both the MoBo bios and the SSD.
• Replaced all SATA cables
• Moved to another SATA controller port
• Switched power cables
• SSDLife came back saying the drive is healthy

I am literally out of ideas at this point, and the issue is extremely annoying. Sometimes my boot times are 30 seconds (if it sees the drive) sometimes it's 20 minutes (constant reboots until it sees the drive).

Anyone have any other ideas, or have seen this before?

 

Unable to boot Windows after cloning it to SSD

Hi,



Thank you for writing to Microsoft Community Forums.



I understand that you are facing issues while booting the PC after cloning Windows to new SSD. I would like to know what happens when you try to boot the PC to desktop using SSD?



The reason you are not able to boot the PC is that the files required to boot Windows are still recognizing the HDD as the main drive. I would suggest you to try rebuilding the BCD files and see if you are able to boot the PC using
SSD.



Kindly follow the steps below to rebuild the BCD.

1. Create a bootable media and boot the PC using the media.
2. On the Install Windows screen, select Next >
   Repair your computer.
3. On the System Recovery Options screen, select
   Troubleshoot> Advanced options > Command Prompt.
4. Now type in the commands and hit enter: BOOTREC /FIXMBR
   
   BOOTREC /FIXBOOT
   
   BOOTREC /scanos
   
   BOOTREC /rebuildbcd
5. Restart the PC.

If the issue persists, please get back to us with the results of the troubleshooting steps to assist you further.



Regards,

Prakhar Khare

Microsoft Community – Moderator

 

SSD as Boot Drive? How?

Well, I have Windows installed on the SSD, along with the drivers and browser. Now, I'm trying to install other stuff (Steam, games, etc.), but the mechanical drive isn't showing. I'm sure I missed a step?