Windows 10: Spark in computer like 2 years ago or less need help

Long time ago had some problems with my laptop ASUS VivoBook 15 X515JA Core i5 10th Gen 256 GB SSD 15.6" FHD Laptop https://www.startech.com.bd/asus-vivobook-15-x515ja-core-i5-10th-gen-laptop#:~:text=The%20latest%20price%20of%20ASUS,in%20Bangladesh%20is%2068%2C000৳. and i tried fixing it. I was going to drain the power, i pulled the battery wire bracket thing to hard and pushed it back into the circuitry and it sparked ever since my computer was the never the same. The red box indicates what i think could have been affected by the damage and the blue box indicates where the spark took pla

:)

 

help to remote connect

not sure how to use both programs u 2 suggested, i need more helpful steps thanks

 

Mouse stopped working 2 days ago

Hi,

There are a lot of possible reasons for this matter to occur. One possible cause is your
drivers
might be
outdated
or the issue is within the
device/hardware
itself. However, we need to make sure that it is the case. To isolate the issue, we have
some questions for you:

• 
  Were there any changes made before the issue occurred?
  
• 
  Have you tried downloading and installing the latest driver update available in your computer/laptop manufacturer's
  website?
  
• 
  Have you tried using the device to another computer?
  
• 
  What troubleshooting steps have you done so far?
  

We suggest that you perform these
methods of troubleshooting
and check if there are any changes:

Method 1: Run Hardware and Device Troubleshooter.

To run the Troubleshooter, follow these steps:

• 
  On the search bar, type
  Troubleshooting
  and hit
  Enter.
  
• 
  Choose
  Hardware and Sound.
  
• 
  Click on
  Hardware and Devices
  to run the
  Troubleshooter.
  

Method 2: Update your drivers.

To know how to update your drivers, click
here.

Method 3:
Run SFC Scan.  

SFC
will
scan
and
run
an
automatic repair
to any
corrupted system files
that it will detect. We suggest that you perform it twice. To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

If the issue persists, we suggest that you contact your
Device Vendor manufacturer
for further assistance.

Update us on how it goes.

Regards.

 

Project Spark Install Problems For Windows 10.

Hi,

Thank you for posting your query on Microsoft Community.

I would suggest you to provide some information to help you better.

• Are you facing this issue specific to the Project spark app?
  
• Are there any 3rd party Security software installed?

Let’s try with the below steps to try resolving the issue.

Method 1: Try a Windows store resetting.

1. Press Windows + R key.

2. Type wsreset and hit Enter.
Windows store will reset and start. If the issue persists then try performing a clean boot.

Method 2: Put the computer into clean boot
state then try installing.
To disable all non-Microsoft services consult the article called Clean Boot.

Follow:
https://support.microsoft.com/en-us/kb/929135

Note: After troubleshooting, refer to this section "How to reset the computer to start normally after clean boot troubleshooting"

Disclaimer: A clean boot is performed to start Windows by using a minimal set of drivers and startup programs. This helps eliminate software conflicts that occur when you install a program or an update or when you run a program in Windows.
You may also troubleshoot or determine what conflict is causing the problem by performing a clean boot.

Keep us informed if the issue is resolved. We are glad to help you further.