Windows 10: Scanning and repairing drive stuck at 100%.

I use the command `chkdsk /f /r` to check the disk weekly, but today it runs to 100% and suddenly shuts down, then restarts and shows error 0xc000025. I tried restarting, but it still runs the disk check again. When it reaches 100%, it gets stuck if I press skip, it freezes at 5 seconds and does not continue. I tried entering repair modes safe mode, but the disk check tool starts again, preventing me from doing anything.

:)

 

Scanning and Repairing drive (C: stuck at 100%

I restarted my Lenovo laptop the other day to its factory settings, and it's been stuck at 100% for Scanning and repairing drive (C since yesterday when I woke up. So it's basically been stuck for an entire 24+ hours at 100%. What do I do?

 

Stuck repairing and scanning c drive 100% complete

On start up my computer says scanning and repairing drive c 100 % complete but appears stuck

 

Scanning and Repairing Drive C 100% Complete - STUCK

When my computer does a chkdsk /r, and restarts, the scan will get stuck on 100%. I've let it sit for over 16 hours and it stays stuck. If I hit the reset button, it''ll restart, the Scanning and Repairing Drive C 100% Complete momentarily comes up, but then it moves forward and boots up to my desktop. I see this is a known problem and have tried several different so called solutions I've found on the internet to no avail. Can anyone help me?