Windows 10: My desktop stuck at windows logo after bios update.

I updated my bios.After update my bios, My desktop stuck at windows logo. It doesn't have spinning dots.Only windows logo.My desktopryzen 5 5600xB550M mortar max wifirtx 3060ti32gb ramI used method of use mountvol command, but I don't know it can be problem.What did I tryCSM Enable/DisableEnable/Disable Secure bootChange boot orderRestore systemRoll back bios versionBios version what i tried7C94v1K7C94v1J7C94v1I7C94v1C Version what before update biosIf i enable csm, it shows windows logo only.If i disable csm, it shows MAG logo only.I can boot in safe mode.

:)

 

Installation Hangs at Blue Windows Logo, Error Code C1900101-20017

The BIOS update suggestion posted above by @Jegler helped me, @guhanath. I was on version 1.10 and updated to 1.90. The steps I took after that were just doing the official Windows 10 upgrade procedure.

Then the Windows 10 installation went without a hitch, and I'm no longer on Windows 7. I'm going to consider this solved, thank you @Jelger for the suggestion to update the BIOS!

 

windows update stuck at installation screen and cannot get to desktop

Hi Sue,

To understand the issue better, I would like to ask some questions:

• Is the computer stuck in the Installing updates screen?
• For how long is the computer stuck in the screen?
• When was the computer last updated?
• Is the screen showing any percentage of installation?

Sometimes the installation might take a long time to install if the update is of large size. So, I suggest you to wait for sometime and check if the system boots to the desktop. If it is taking a longer time, then perform a Power Drain by following the steps
provided below:

• Shut down the Computer.
• Remove all power source (including battery if it is a laptop).
• Press and hold the power button for 15-20 seconds.
• Connect the power source and start the computer.
• After the computer boots to the desktop, suggest you to install all the pending updates.

Hope this helps. Keep us posted on the status for further assistance.

Thank you.

 

PC stuck at windows logo and ram question

Sounds pretty close to my experience. As the PC is 13 years old, the update could be the cause and if the PC is turned off/restarted while loading Windows there will almost certainly be corrupt system files, hence the repair during start-up. Have you tried reinstalling all the original RAM, turning the PC on and then leaving the PC for a while to see if it loads after, say 5 mins? The issue with the update really does look like the PC has hung and/or crashed as it is searching the BIOS for the database file - the spinning dot animation freezes and the keyboard Caps/Num lock buttons are unresponsive...the culprit, for me, was KB5012170: Security update for Secure Boot DBX ( this always failed to install within the Windows Update environment ). For my 12-year-old PC, I just turn it on and make a cup of coffee, and when I return I am in Windows. A bit of a pain - before this update ( or Win10 fail ) the PC would be on the desktop screen within 30 sec.