Windows 10: My BSOD time has come. I've been going thru my old hard drives, and after the 3rd one I...

My BSOD time has come. I've been going thru my old hard drives to make sure that I didn't leave anything important on them. Once I know there is nothing important, I have been deleting the volumes and leaving them unformatted. After successfully doing this with 2 old hard drives, I moved onto my old m.2 nvme drives. The first one ended up being my old boot drive that I had used to clone the new one that I've been using without issues for some time now. The process for this one was a little different, because Windows Disk Management didn't give me the option to delete the old boot partitions. B

:)

 

Boot from old hard drive

The motherboard of my old computer died suddenly and so I bought a new computer. It has two 1TB HDDs on RAID 0 and comes preinstalled with Windows 10 Home. I wanted my computer to boot from my old 120GB SSD from my old computer but it doesn't seem to recognize it as boot drive. It was working perfectly with my old computer.

I can view files from the SSD and so this confirms that it is working. The boot partition is marked active.

I tried changing the boot hard drive in the bios but in the bios, the only two options shown in the boot menu are

• Windows Boot Manager (Intel Volume1)
  
• CD/DVDRW
  

After searching online, a website suggested swapping the Sata of the old hard drive with that of the new one. I tried even this but this didn't work either. It gave me the error "boot disk not found" and in the boot menu, the only option was "CD/DVDRW".

For Reference :

Motherboard : ASUS Z170 PRO GAMING

All Hard Drives Run GPT.

Any other solutions?

 

Overclock your hard drive!!!

Heres a much easier hack that I realized quite a few years ago that really does work!

REQUIREMENTS:

• Hard drive with molex power connection.
• PSU with more than 1 strand that has molex plugs on it.
• Wire strippers, soldering iron if you're fancy, electrical tape if you're not.

STEPS:

• Take the strand of connectors from your PSU, and decide which one will be the donator for this overclocking adventure.
• Cut the yellow and orange cables, then twist them together.
• Find the power connector you've chosen as the overclocking connector, and release the orange cable from the connector. Now use your preferred method to bind them together, then place it back together.
• Plug in a drive and feel the speed!

Congratulations! You've just overclocked your hard drive!

 

new system old hard drive...

I have an old hard drive that has those old ribbon connections to transfer data to the mother board.

I have a new computer that mostly uses those cool little ATA (I think that is what they are called) connections.

The new computer has a Vista OS.

I opened up the case and I was supprised to see on the motherboard a wide ribbon connection and so I connected the old hard drive and a free power connection.

When I turned on the computer, the system started up like usual and did not notice the new hard drive.

I went to the Control Pannel and did an automatic add hard drive call and it did not find the old hard drive.

Any suggestions?