Windows 10: Ive been having some trouble with my system files for awhile now. I believe some of them...

So i got this computer from someone and it runs great but ive found out some how when the dude installed windows 11 it looks like he installed it between 2 drives Note both drives have 2tb i dont know why he would have done this or even how and that could possibly be the reason why its having problem's. Here are the problems: when i open certain applications for example Opera Gx it will open for a few seconds and then close and reopen not a big issue but kinda of annoying, next I wasn't able to download an update but i just fixed this one i ran in command prompt /Online /Cleanup-image /

:)

 

No beeps at POST, possibly system panel connector help

Believe what you want. Your asking for suggestions . Ive seen whole systems go bad at the same time and these suggestions are standard trouble shooting procedures. Just start over sometimes that works

 

Having trouble with port forwarding..

I am currently a bit occupied and can't focus 100%.

Give me some time to write a full check list for you. That manual helps a lot in doing all this.

I will return once I've written everything in a clear and step by step tutorial. I also have D2, so I will test it on my system, which also takes time.

 

Having trouble renaming files in windows 10.

Hi Varin,

Thank you for posting in Microsoft Community and being part of Windows 10.

As you are unable to rename the files I understand the inconvenience. We will help you with this issue.

Do let us know the following to assist you better with this issue:

• Were you able to see any error code/ error message with this issue?
• Is this issue confined to any particular file in any specific folder/ drive?

Try the below steps and check if it helps.

Step 1: I suggest you to boot the computer to Safe Mode and check if the issue occurs or not. In Safe Mode computer starts with minimal set of drivers and files.

Refer: Start your PC in safe mode in Windows 10


Step 2: I suggest you to perform
Clean boot to avoid any third party software conflict.

Disclaimer: Putting your system in
Clean Boot state helps in identifying if any third party applications or startup items are causing the issue. You need to follow the steps from the article mentioned below to perform a Clean Boot.

How to perform a clean boot in Windows

(Applies to Windows 10 as well)

Note: Refer "How to reset the computer to start normally after clean boot troubleshooting" to reset the computer to start as normal after troubleshooting.

Step 3: I suggest you to boot the device to Normal mode and check if the issue persists.

Follow the below steps to place the computer in normal mode:

• Press Windows + R keys to open Run
  command.
• Type msconfig and press Enter.
• In the System Configuration window, click on
  General tab.
• Select Start-up selection as Normal startup, click on
  Apply and Ok.
• Follow onscreen instructions.

Hope it helps. Try the above and update us the status of this issue for further assistance.