Windows 10: Im getting BSOD, not sure what is causing it.

minidump files are here:https://1drv.ms/f/c/8613ebda2ac6453e/Emuz9nr29PZJhYJwT9i6DuABlc7gNQlQoKWXIPbeAglBHQ?e=iy2PXH

:)

 

BSOD Hardware Caused???

they do weird things like that, which all seem like something else is failing.
One of the worst things to diagnose, they seem to only quit when they want to.

Memtest is a good next step, if you rule out RAM and Power Supply make sure you disconnect all unnecessary peripherals and try to start the system with as little hardware as possible, if it works then, you can narrow down the culprit by trial and error.

the follow was taken from some website:

It's very difficult to determine if a failure is caused by the CPU because many other components can cause the same symptom when they fail.

1. System fails to boot
2. System re-boots intermittently
3. General Protection Fault
4. Illegal Operation
5. Stop Error, or BSoD (Blue Screen OfDeath)

Actually, CPUs rarely fail, and about the only way to determine if the CPU is causing the failure is to swap it out with a known working CPU of the same type and speed. Since this is difficult, the best bet is to first rule out every other possibility.

Before suspecting the CPU, rule out all the possibilities listed below.

1. The Operating System
2. A peripheral port device
3. A bad memory module
4. The hard disk drive
5. The power supply
6. The motherboard

If you have ruled out out all the other possibilities, investigate the items listed below.

1. Overheating
2. A short circuit
3. ESD

 

Screen tearing not sure of cause

You posted a lot of information. That isn't a bad thing, but I would say a good chunk of people coming into the thread are going to be put off by it.

What I would suggest is taking the information you have there and short-handing it. People find it more readable to go down through a list of what has occurred and what you've done about it so far.

I'm sure someone will be along to help. That your mobo threw a beep code suggesting memory, and you ran 4 passes on it (MemTest?) without any problems, maybe you're looking at a problem with the mobo.

Again, try and shorthand your post.

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.