Windows 10: I2C HID device not working and showing error code 10

I2C HID device not working and showing error code 10

:)

 

I2C HID Device not working properly. Showing code 10 error

I2C HID Device not working properly. Showing code 10 error.

I've already tried these below solutions but couldn't resolve:

1. Updated BIOS.

2. Disabled and again enabled the concerned driver.

3. Driver updates (Windows not showing any updates for I2C HID device).

4. Switched to Windows 11.

Could anyone please help in this regard.

Note: Windows version is 21H2.

 

Touch screen stops working -I2C HID device error

I have a LG gram laptop 16T90P-KAAE7UI running windows 11. In the last few months, touch screen has been intermittely stopping working. The device manager always showed there was an error in I2C HID device - This device cannot start (code 10). Usually, I could recover by doing one of the following things:

• disabling and enabling the device,
  
• simply rebooting the system or
  
• uninstalling the device and then restart the laptop.
  

Today, after pushing the sleep button on the side of the laptop and then pushing it again to wake up the laptop, touch screen completely stopped working. None of the methods mentioned above works. Touch screen function refues to work and device manager always shows that I2C HID device cannot start (code 10). The following message appeared with recovery attempts

• A request for the HID descriptor failed (most often), or
  
• The device failed the SET_POWER command, or
  
• One byte was expected in the report descriptor but not found
  

I also did update from Windows update and LG update center. All things have been updated to date. No luck to make touch screen work again.

Touchpad always works without issue. What else can I do to fix the I2C HID device error and bring touch screen back to work?

Thanks.

 

Touchscreen not working - I2C HID Device Code 10

Please help,

My notebook touchscreen was playing up before (tapping a few times before it responded). I decided to restart and now it doesn't work at all. Device Manager says I2C HID Device (which the HID Touchscreen and Pen are 'on') is on code 10 - Device cannot start. Tried:

• Restart - no luck
  
• SFC - no luck
  
• Remove device - no luck
  
• Update device driver (Error codes in Device Manager in Windows (microsoft.com)) - No luck - can't even update because I get the same CODE 10!!!
  
• Restarting even MORE - no luck
  
• Checking web - Other people had same problem but was not resolved.
  
• Installing I/O driver - it's 'on' Intel(R) Serial IO I2C Host Controller - 9D61 (you can look at the website here: Product Support for Acer Switch 5| Acer Australia)
  

PLEASE HELP ME!!!