Windows 10: I keep getting blue screen stop code AuFSProcDrv.sys

I keep getting blue screen stop code AuFSProcDrv.sys I read in another post how to delete this driver but when I followed the instructions on how to get to this driver and delete it, it doesn't show this driver being there?

:)

 

Blue screen and stop code

Hi
Jeferis,

There are a lot of factors for this matter to occur. To isolate the issue, we have some questions for you:

• 
  What activity have you done to
  trigger the NTFS and FAT FILE SYS loop?
  
• 
  were there any error messages?
  
• 
  What troubleshooting steps have you done so far?
  

It is possible that the
Boot
Sequence were corrupted by the previous activity which
triggered the Blue Screen Error and the loop. We recommend that you perform these
suggested troubleshooting
and see if there are any changes:

Startup Repair.


To access the
Startup Repair Screen, turn off the
PC 3-4 times(force shutdown),
while on the Blue screen Error. This will route you to the
Startup repair screen:

Advanced Boot Options > click Troubleshoot > Advanced options > Command Prompt

and run the following command:

Run SFC Scan:  

SFC
will
scan
and
run
an
automatic repair
to any
corrupted system files
that it will detect. We suggest that you perform it twice. To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Boot Record:

This will fix the corruptions on
boot records or boot
sequence. To run this command, follow these steps:

• 
  Run
  Command Prompt as Administrator.
  
• 
  Type the following command:  
  
  • 
    Bootrec /fixMBR  
    
  • 
    Bootrec /fixBoot
    
  • 
    Bootrec /rebuildBCD
    

Update us on how it goes.

Regards.

 

getting blue screen error/Stop Code

Hi Abhijit,

Stop code: DRIVER_POWER_STATE_FAILURE is probably due to a compatibility issue with the driver, as most blue screen errors are. Since you encountered this error after updating Windows, most probably, you would need to update the drivers
as well.

We suggest that you go through the steps in this article on how to troubleshoot blue screen errors.
On step 1, select After an update was installed.

Kindly update us on the results.

 

BLUE SCREEN STOP CODE KMODE EXCEPTION NOT HANDLED

I have followed the numerous steps advised by Microsoft to get into my account, have also done a complete system check. All is 100%. but I am still getting a blue screen with the above stop code. Any other suggestions out there???