Windows 10: i dont know what to do i cant even reset this pc nothing is wrorking

plesase some one help me with this even the indian youtubers cant help me.

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Problem with windows 10 i dont know what exactly.

Thank you for the information you've provided. Since you've already tried disconnecting all external devices and the same issue persists, the next step that we recommend is to use a recovery drive to restore your PC. To do that, click on this
link and look for the steps under
Use a recovery drive to restore or reset your PC.

If you don't have a recovery drive, you can create one on a working PC. If restoring your device from a system restore point did not solve the issue, we suggest that you reset your device. The steps for creating a recovery drive and how to reset your PC
was also provided on the same link. Look for the following:

• Create a recovery drive
• Reset your PC

Keep us updated if you need further assistance.

 

I THINK MY PC RESET IS FROZEN?

Hello,

To help you resolve your concern, we suggest that you follow the instructions below:

Power cycle your device. Here are the steps:

• Force shutdown your computer by pressing and holding the power button down for 5 to 10 seconds.
• Remove all the attached cables for 2 minutes then put them back on.

If the same thing happens, we suggest that you perform the reset again.

Let us know how it goes.