Windows 10: How do I get to CMD?

How do I enter CMD to type in a command?

:)

 

Windows and CMD- renaming a file in CMD

Steps I've done

Here what happens

• 
  turn on PC
  
• 
  start windows
  
• 
  get blue screen ( message NTFS file)
  
• 
  it reboots returns to diagnosing PC
  
• 
  Diagnose and repair fails
  
• 
  I move to advance options
  
• 
  will not reset windows , I click on CMD
  

things I've tried
commands:

reagentc /disable

reagentc /enable

*************************FAILED
not recognized
**********************************

Please advise

• 
  

 

laptop doesnt boot automatically

This is what happened.

1. Did a repair install and later disabled hibertnate in CMD.
2. Enabled legacy option ROM in BIOS.
3. After a few times startup ( i used the system in such mode for 5 days), changed boot option back to default.
4. Vola!! It boots automatically to win10 without any keypress. Tested it with many starts to confirm the same.
5. Re-enabled hibernate option using CMD and later selected Fast Startup.
6. System booted normally, without the need for any keypress.

I do not know exactly whether such steps resolved the problem or what else happened, hence cannot suggest above steps.

Many thanks to all members who helped to troubleshoot problems.

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!