Windows 10: Event Viewer stopped showing new events

I go to Event Viewer > Applications and Services Logs > Microsoft > Windows > Diagnostics-Performance > Operational.But there are no events listed for the past several weeks even though I’ve rebooted many times during that period. I clicked the Refresh button in the right column and this added one new event - the

:)

 

Error in Event Viewer

Hi,



Thank you for writing to Microsoft Community Forums.



As you have mentioned, you have performed a repair installation on the computer and you see Event 508, 510 and 533 in Event Viewer.



I would like to inform that if you see any critical error in Event Viewer, please share the event logs with us to help you with the appropriate troubleshooting steps. Please follow the steps mentioned below to share the event logs:

1. Press Windows + X from the keyboard, select
   Event Viewer.
   
2. Expand Windows Logs from the left pane and select
   Applications.
   
3. Click Filter Current Log from extreme right pane. Then in the new windows check the box beside
   Error and click OK.
   
4. Now, look for a critical Error in the list and note down the message/information from the
   General Tab in the lower section.
   

Please reply with the status of the issue, we will be glad to help you further.



Regards,

Nikhar Khare

Microsoft Community - Moderator

 

Disabling Event ID 1074 to show up at event viewer

In short, you cannot.

You cannot stop that event from showing in the event viewer.

This ID states the shut-off time of the device.

This event ID is an essential action that the device takes.

It will be present in the event viewer by default and that cannot be changed.

 

Event Viewer problem with latest Windows Build 1607

After installing the new Windows build 1607, the Event Viewer stopped recording events under Diagnostic Performance. (Before 1607 I checked the files located under Windows.old dated 9/23/2016 and located this file which indeed did have a list of events
recorded.)

Since the initial 1607 download there have been two new builds automatically installed on my laptop.



The last step in an automatic download is the RESTART. Prior to my rebooting, I checked the Diagnostic Performance and for sure, these had the list of events.



Rebooting by me, causes the Diagnostic Performance errors to disappear.

As suggested earlier I have run the SFC/DISM commands with no errors reported.

Any Ideas?

Nancy