Windows 10: diskpart

How to format whole harddrive and then create partition of Harddrive for Window 10 installation through diskpart . Please give me full step for same

:)

 

Faulty harddrives

Thanks for the suggestion but as I stated the drive doesn't show up in Disk management. I just tried the Diskpart steps and it's not listed on there either

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

Diskpart problems?

Hi again, I tried what you suggested and got the same error message as before. I spoke to a guy on another forum and he suggested typing the "Active" command before doing the Format.
diskpart
list disk
select disk # <-replace # with the actual number for the USB flash drive
clean
create partition primary
select partition 1
active
format fs=fat32 quick
He tried it on a Windows 7 PC with the Active command straight after format and he was told to select a partition again...but when selecting Active first before format it was fine.
Im thinking that might be the case on my Windows 10 laptop too but instead of getting a reminder to select a partition I get an error. After the error message If I select a partition and Type Active everything is OK. It seems a bit strange I know!!

Can I ask you though. Is it OK to type the Active command before the Format command or should Active only be typed into Diskpart after the Format has been done?