Windows 10: Disk not showing up in diskpart but shows up on disk management

A about a day ago my pc started taking over 5 minutes to boot up and would boot into my bios, I managed to reinstall windows, but now my Disk 0 doesnt want to initialize. When i was reinstalling windows i did notice that when i when through the diskpart, its status was failed. but now that windows is installed it just doesnt show up at all.Disk 1 + 2 are connected in a raid volume and disk 3 contains windows 10Is there any way to fix it? i checked its connections and power, even tried switching sata cables and sata ports

:)

 

Disk showing in Disk Management, But not DiskPart

Hello!

So, today I was doing a friend a favor, he had an old 1TB hard drive with important photos on it. He said he would appreciate it if I could move the photos to a different hard drive.

So, I hooked it up to my self-built PC (with a SATA port) and it didn't show up in file explorer.

So, I checked Disk Management to see if it would show up there, and it did. I later realized why it didn't show up in file explorer (Because it didn't have a drive letter). In Disk Management, I right clicked the primary partition only to find that it wouldn't
let me assign a drive letter.

I remembered there was another way to assign drive letters, with DiskPart. So I typed this into Command Prompt:

diskpart > list volume

In DiskPart, It showed the drive's EFI system partition (partition 1) but not the (Healthy) Primary Partition (partition 2).

Also in DiskPart, I could type "list disk" and it would show me the 1TB drive, if I then typed "list partition" it would show me the different partitions, but wouldn't let me assign a drive letter to them.

In summary, Disk Management showed the partition, but wouldn't assign a drive letter. DiskPart showed the partition 1, but not the primary partition.

My objective is to show the photos located on the 1TB drive's 2nd partition without erasing it.

I would be happy to add pictures if necessary.

Thanks!

 

diskpart doesn't show disk

Hey,

I am trying to install Win10 on a mac book air.

However the diskpart does not list the disk even after reformatting the partition as NTFS per suggestion.

read through this solution but cannot move to step 1 listed in the solution by Ivan as that disk doesn't see that partition it was just able to reformat.

Regards

 

Disk management console view is not up-to-date

i dont know how to fix your disk management, but i can fix your partition problems...




open up Command Prompt with admin rights. (Right click, run as admin)


enter in
DISKPART
list disk

then find the Disk number for your Raid array... lets call it number 7 ( you can tell what disk is what by the total size)
type in

Select Disk 7
List Partition (will give you a list of all the partitions..)
Select Partition 1 (im assuming you only have 1 partition on Disk 7) repeat this step if you have more partitions.
ASSIGN


that should get the array up and running ready to use.


EDITED.

any problems, post back ^^


Still EDITING *Stick Out Tongue

side question, have you tried restarting the PC?