Windows 10: Changing hard disk drive priority

Alright, so I have 2 SSD's in my computer, one Samsung and one off brand. When going into the BIOS boot menu I find that the number one prioritized hard drive is the so called "Windows Boot Manager" and the second one is the Samsung it says its full name. So the question is should I change the priority of these two because I want to boot from the Samsung SSD which has been working fine for a few months and if the "Windows Boot Manager" is in fact the older SSD why is it called that and not just it's name?

:)

 

Hard drive shows up in device manager but no in disk management

I could not found my hard drive list disk, only my working ones. I tried following the steps anyway and nothing changed.

 

How to Partiton a Hard Drive in Vista

This is a way to get Vista to see another hard drive that is not associated with the OS. There is some times when your new hdd doesn't seem to want to work well with Vista. But, there is a solution in it.

Open the Computer Management By doing these steps.

• Click on the Start Button
• Click on Control Panel
• Click Administrative Tools
• Double click on Computer Management

You are now in the Navigation panel of the Computer Management.
When in Computer Management, you then have to allow the new drive to be recognized.

• Double click on Storage
• Double click on Disk Management

Now in the middle of your screen there is the layout of the Disk Drives that you have. The drives that are partitioned will show by the drive lettering. The others will just show up as having nothing at all in them. Below that there will be the Disk drives that are installed into the computer. You'll see that the primary one will all ways read as "Disk 0". Then you will have Disk 1 and so on. Under the Disks there will also see your CD-Rom drives.. If there is more then one, it will be labeled the same as Disk drives..

On to the Partitioning of the drive in question.

• Right Click on the drive
• Click to format the drive or Enable Volume. There will be a series of windows that open up. This is Vista's formatting. Just go threw the windows, and make sure everything is the way you want it to happen.
• Once the formatting is done, will take some time depending on the drive size.
• Right click on the drive
• Click on Mark the Partition as Active

After you have done those steps, The drive will be up and running threw Vista.



:Side Notes:
If you are not the Administer to the Os, then you will have to enable it..
You may also want to redo the drive lettering of it all. But, I really don't see a reason to do so. If you do, you have to redo drive paths and so forth.. A lot of work on something so small...

 

HARD DISK DRIVE ERROR

Hi Aditya,

In order for us to help you with your concern about hard disk drive error, kindly answer the following questions first:

• What specific error are you getting? Are you getting an alpha-numeric error codes such as 0x80070057? If possible, kindly post here a screen shot of the actual error.
  
• What troubleshooting steps have you tried so far?
• For initial troubleshooting steps, kindly access this
  support link.

We look forward to your response.

Regards.