Windows 10: BSOD KMODE_EXCEPTION_NOT_HANDLED while formatting disk partition

Hello,I always encounter this BSOD Kmode exception not handled when I do something with my disk, specifically, when I try to format a partition disk for it is RAW. I already tried updating my drivers but the problem persists. I tried using BlueScreenView to figure out the cause of the BSOD, and it says "Caused by Driver ntoskrnl.exe" and "Caused by Address ntoskrnl.exe+3f71d0".This is the minidump file of the said BSOD:https://1drv.ms/u/s!ArHSwGCgTpXhjAHhPaH7W3woP5zz?e=o9akY9Hoping that someone can help me fix this issue. Thank you.

:)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

W7 Hard drive partition issue

to get rid of that 100 meg windows partition that setup creates for you on a new install on a blank hdd:

- press shift+f10 when on the partition management screen in setup <-- this opens a command prompt
- diskpart <-- start the windows command line partition management tool
- list disk <--- list the installed hdds in this computer for the next step
- select disk 0 <- might have to replace 0 with the number of the correct disk
- clean <-- this will erase all data on the disk you selected one step up- dont use the wrong disk!
- create partition primary <- creates a primary partition taking up all space on the drive, adjust the command if necessary
- exit, exit to exit diskpart and the command prompt
- click refresh in partition manager and select your newly created partition and install to that

 

Hard disk partitioning

Step 1: Connect the external drive and make sure it is powered on.

Step 2: press Windows key + X then click Disk Management

Step 3: You will see the external drive listed in Disk Managment.

Right click each partition, starting from the extreme right, then click Delete.

You should only see one unallocated drive

After all are deleted, right click it then click Format

This will start a wizard

Choose NTFS for the file system then label it then click Next to begin the format.