Windows 10: BCDEDIT - In need of help adjusting settings

ello,


I did a bit of reading on micro lag/stutter and I'm working to resolve it on a new laptop. I had uncovered an article that said to run the below two commands. I ran the first as an admin in commandprompt - I saw little difference. I ran the second and my system ran horrible for a min or so before I undid the command with the third. I feel as if it impacted my computer adversely. I reformatted the computer fully later that day.


bcdedit /set disabledynamictick yes

bcdedit /set useplatformclock yes

bcdedit /set useplatformclock no


I'm worried for the computer/processor. What did it do? How can I undo it? I read further, does TSC need to be re-enabled?


Any advice would be helpful. Thank you.


cheers,

:)

 

Adjust brightness settings in Windows 10

Hi Vicky,

I understand that you want to adjust the brightness of the computer. I will certainly assist you.

Please answer the below questions to assist you better.

1. What is the make and model of the computer?

2. From where exactly are you trying to adjust the brightness?

I suggest you to follow the below steps and check if it helps.

• Type Settings in the Search bar and then Enter.
• Click on the System and then Notifications and Actions which is available on the Left pane.
• Click on Add or Remove quick Actions.
• In the make sure that the Brightness is ON.
• Then click on the Action Center and adjust the Brightness according to your preference.

Hope this helps. Please get back to us with more information if the issue persists, or if you have any queries related to Windows. We are here to assist you.

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.

 

Brightness can not be adjusted.

Hi Sirajudeen,

Do let us know the following to assist you better with this issue:

• What is the make and model of your device?
• Were you able to see any error message/ error code with this issue?
• Have you tried to install all the pending updates for drivers and Windows Updates on your device?

This issue might have happened due to corrupted/ outdated drivers.

I suggest you to refer to the below Microsoft article, try the troubleshooting steps suggested to change the brightness and check if it helps.

Adjust your monitor's brightness and contrast


Hope it helps. Get back to us with an updated status of changing the brightness and required information for further assistance.

Thank you.