Windows 10: automatic repair loop but no troubleshooting options

i’ve asked about this before and was told to just download a media creation tool and reinstall windows to my pc. i did that. nothing changed. i was told to reset my uefi settings to default. didnt do anything. i tried powering off and unplugging everything except mouse and keyboard. that did nothing. the usb doesn’t have a repair computer option available so i can’t try that. and the automatic repair doesn’t ever even start. just pops up and then black screens me. i turn my pc on, it loads like normal for about 5 seconds, gets to the windows logo and shows the little dotted loading bar for a s

:)

 

Automatic Repair Loop

Hi Charlene,

Your concern regarding the device going into an Automatic Repair Loop can be caused by change on its settings/configuration or broken system files. To effectively assist you with your concern, can confirm if you've made any changes on your device prior to
your concern?

As an initial step to get back into the normal Windows screen, we suggest that you perform a
Startup repair. The repair will attempt to fix any broken components/files which may prevent your device from booting properly. To do this, follow the steps below:

• On theAutomatic Repair screen, select Advanced options.
• Select Troubleshoot.
• Select Advanced options.
• Select Startup Repair.

We'll appreciate if you can send us an update.

 

Automatic Repair Loop

Hi,

Unsuccessful installation of an update could be a possible cause why you are experiencing the automatic repair loop. To address this concern, we suggest running the Startup Repair tool using your bootable USB. This tool can scan and repair damaged system
files. Follow these steps to run the Startup Repair tool:

• Insert the bootable USB and boot Windows 10 from it.
• In the Windows Setup page, select the language to install, Time and currency format and the keyboard or input method and click on Next.
• Click on Repair your computer and select Troubleshoot.
• Click on Advanced options and select Automatic Repair and select the operating system. You might also require changing the boot priority in BIOS in order to allow the computer to boot from CD/DVD.

Important: While scanning the hard drive if any bad sectors are found, the scanner tries to repair that sector, any data available on that might be lost.

Note: Modifying BIOS settings incorrectly can cause serious problems that may prevent your computer from booting properly. Microsoft cannot guarantee that any problems resulting from the configuring of BIOS/CMOS settings can be solved. Modifications
of the settings are at your own risk.

Keep us updated about the result.

 

Preparing Automatic Repair/Diagnosing Your PC Loop

Hi,

To resolve your concern with continuously looping your system, we suggest that you follow the Startup Repair steps below:

• Turn off your computer.
• Turn on your computer. As soon as you see the Windows logo with the spinning dots, press and hold down the power button until your computer turns off. Do this process
  twice.
• Turn on your computer for the third time, and let it load.
• It should give you the message: Preparing Automatic Repair.
• On the next screen that would appear, click on Advanced Options.
• Select Troubleshoot.
• Go to Advanced Options.
• Click on Startup Repair.
• Wait for the repair to finish.

We would appreciate it if you could get back to us and provide us your feedback.