Windows 10: I keep getting a BSOD error titled "DPC_WATCHDOG_VIOLATION" and I can't fix it.

I've updated windows and every driver I can find, and I've even applied new thermal paste but that still doesn't seem to fix the problem.

:)

 

how to fix DPC_WATCHDOG_VIOLATION ?

I have been getting this error recently, and it has been getting quite annoying to get BSOD, how can I fix?

DPC_WATCHDOG_VIOLATION

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.

 

Windows 10 DPC_WATCHDOG_VIOLATION on restart

Hello Tom,

There may be several reasons why you are getting this DPC_WATCHDOG_VIOLATION. To assist you better with this concern, kindly answer the following questions:

• When did this issue started happening?
• Does this error come with an error code/number?
• What troubleshooting steps have you done aside from the ones mentioned above?

In the meantime, you can check on this
thread and refer to the post of ZigZag3143 (MS -MVP). It discusses steps on what you can do with these kinds of stop errors.

We're looking forward for our reply.