Windows 10: Problems while installing windows 11 on GPT UEFI

The issue is that I can't boot with uefi on my USB with the win install, used rufus with gpt no csm configuration, also tried with windows install tool that downloads the iso and burns it into the USB, it will never work, always tells me that there was an I/O error and 0xc00000e9 error, gives me multiple options and if I try to select F9 I think that it is the recovery settings, it gives me an 98 or 90 ending error like the above one that it couldn't find bcd, the only option that I found for installing win11 was bypassing with rufus the tpm and secure boot requeriment, installing it on MBR on

:)

 

Trouble installing windows 7 on RAID in UEFI

As the title says, I'm trying to install Windows on a RAID array in uefi on my Maximus V Formula. When using legacy ROM I can install just fine but I go into CSM and change settings to UEFI only, I can build the array in the UEFI Raid driver (IRST tab in "BIOS") but the array does not show up in the boot menu and when I try to install windows (boot from UEFI DVD drive), The drive does not show up in the Windows install. The next thing I tried was to enable UEFI and legacy oprom in CSM, boot from UEFI DVD drive and install to the RAID array (probably detected by legacy oprom) and it will install. After first reboot, Windows Boot manager will show up as an option in the BIOS boot menu so I set that as first boot device and reboot. I will get to the starting windows screen and then BSOD (too quick to get codes) The last thing I tried was Changing to legacy mode and installing windows to a different drive. once installed, I initialized the Raid array as GPT and rebooted, changed csm back to UEFI only but they RAID array still doesn't show in the boot device list so I repeated the earlier process hoping that It might work because I had initialized as GPT but it still BSODs on starting windows screen. Any help or suggestions would be greatly appreciated

 

Trouble installing windows 7 on RAID in UEFI

I think you were on track with your first try. Windows installer probably needs the RAID driver in order to detect it on install.

 

Trouble installing windows 7 on RAID in UEFI

Did you follow the guide I linked you to? If the volume doesn't show up after doing the list disk command, then you have a problem (drivers don't support GPT, RAID array improperly configured, booted via BIOS instead of UEFI, etc.). If it does, you're good to go. I remember when I did it (it was RAID0), I didn't trust the setup user interface at all until I finished working with diskpart and refreshed. Once I refreshed, the setup user interface caught up to speed (even so, it only showed 2 out of the 3 required partitions for GPT).

It not working the way you expect it to may actually mean it is working the way it should under EFI/GPT.


Edit: Someone else had a similar problem as you are and found no solution. I suspect there might be a lot of poser motherboards out there that pretend to support GPT from UEFI but fail at it. I did my GPT install on an MSI board. MSI was the among the first manufacturers to fully adapt UEFI so they've had ample time to work out the bugs before I tried it (even then, there's quite a few).