Windows 10: Unable to update BCD

I've been trying to create a recovery environment so I can reset my computer for a while now, and whenever I try to, I get the same message about missing required files. I tried fixing the error with the following:reagentc /disable reagentc /setreimage /path \\?\GLOBALROOT\device\harddisk0\partition3\Recovery\WindowsRE reagentc /enable And got the message "Unable to update Boot configuration data". I've tried a whole bunch of things, but nothing seems to work. My computer only has one disk with three partitions.I'm not sure where to go from here. If anyone has any tips, I'd appreciate them.

:)

 

Windows defender offline error: EFI\Microsoft\Boot\BCD - 0xc0000185

Hi Dave,

Could you provide us additional information to assist you better with this issue:

• What is the make and model of your device?
• Have you made any changes to the operating system prior to this issue?
• Are you able to boot the device to desktop with this error message?

This issue might have occurred due to corruption in the boot files or BOIS unable to detect your drive to boot.

I suggest you to refer to the below thread, check if your issue matches with the same.

If so, try the troubleshooting steps suggested by -.[Final]#[Boss].- and check if
it helps.

Error code after update File:\EFI\Microsoft\Boot BCD
Error Code 0xc0000185 BSOD

Hope this information is helpful.

 

Error code 0xc000000f, BCD corrupted

Hi Andre,

As per the description, I suggest that you follow the steps below to fix BCD

1. Right click on the Start Menu and select Command Prompt (Admin)

2. Here type/paste the commands listed below

Bootrec /fixMBR

Bootrec /fixBoot

Bootrec /RebuildBcd

3. Once done restart the PC and check.

Hope this helps

 

How to clean up BCD entries? Rebuild the BCD?

This is normal that under Recovery Environment, The letters are re-assigned. This is why you have to be careful and select the correct one.
@dictum
Advice: Never use Easy BCD with Windows installed using GPT disk. Use Easy UEFI instead provided you know what you are doing. Easy BCD only works with MBR disk type.
Base on the screen shot above. Your disk 0 is your new Windows and your disk 1 contains the old Windows. Disk 3 contains a 512MB Fat32 partition and I don't know what that is. I suggest you disconnect disk 3 for now before proceeding.

Let rebuild new BCD's for both disk 0, and disk 1. Please follow step by step on the 2 screen shots below. On step 3, write down the drive letter for PM981_New. In the screen shot, My Windows is still assigned to C but it might be different from yours. In step 10, if the drive letter is different than C, then use the letter in step 3.

Do exactly the same for disk 1, this time select disk 1 in step 4 and assign letter V in step 7, Use V and the drive letter for Old Windows in step 10. This will create a new BCD for PM981_Old and you will be able to boot separately from boot menu.

From boot menu, select which one to boot from.
Once booted into Windows. If you wish, you can set up dual boot for Windows old & New. Under This PC, look for the drive letter of the offline Windows and type:
bcdboot X:\Windows where X is the letter of the offline Windows