Windows 10: No Label EFI System Partition FAT32 Full repair needed.

I don't know much about Computers but noticed that my "EFI system partition" File system "FAT 32" has the status of Full repair needed when i went in to initialize my new SSD. although when i go in through Windows+X and Disk Management it shows the Disk 1 Partition 1 status as Healthy EFI System Partition. should I address this?

:)

 

Formating Efi system partition as FAT32

Hello,

I reinstalled Windows 10 on my laptop and it had a loop at the setup configuration after the install. I booted from dvd again, and I've started another installation by formatting the partitionwith the new installed windows. And now, when I click next to
choos where to install windows i get an error :Windows detected that the EFI system partition was formatted as NTFS. Format the EFI system partition as FAT32, and restart the installation.

How can I do that?, because i have not windows installed (i have formatted it).

 

UNMOUNTABLE_BOOT_VOLUME after creating new EFI System Partition

I would probably have booted to a Windows install or recovery media to create the

EFI system partition by using Diskpart and the create par efi command with any modifiers necessary to make it fit in the correct location.

I know Linux can use a Microsoft EFI partition but I do know if Windows can use a Linux version.

Yes, the bcd listing which shows the boot manager and OS loader.

It may have been easier to use a third party partition manager to change the size of the EFI partition.

If you might need it, here are the details of an EFI partition from Diskpart.

Partition 2

Type : c12a7328-f81f-11d2-ba4b-00a0c93ec93b

Hidden : Yes

Required: No

Attrib : 0X8000000000000000

Offset in Bytes: 524288000

Volume ### Ltr Label Fs Type Size Status Info

---------- --- ----------- ----- ---------- ------- --------- --------

* Volume 3 FAT32 Partition 99 MB Healthy System

 

Reinstalling Windows: Windows detected that the EFI system partition was formatted as NTFS. Format the EFI system partition as FAT32, and restart the installation.

Just format the system partition and you will be good to go!!