Windows 10: Facing Blue Screen recovery issue after changing partition .

Hey guys.. I hope you're doing well...Lately, I have been facing a problem on my dell laptop which is running in windows 10 os. I have a 250 GB hard disk divided to 2 partitions. I had mucha space in d drive but my c drive was full which is assigned as defualt drive. So i used AMOEI 3rd party partition maater to allocate some space to C drive. After doing so in some mins i am facing blue screen recovery page. I hope you guys can help me. Thx

:)

 

Failure to apply update due to recovery partition issue?

My suggestion would be to:

1) Disable WinRE

2) Delete partitions 4 and 5.

3) Extend the C drive to utilize the unallocated space (minus 750 MB)

4) Create a Recovery partition in that 750 MB unallocated space.

Step 1:

*******

To disable WinRE, run:

• reagentc /disable
  

Next, check if winre.wim has been moved to the c:\windows\system32\Recovery folder. To do so, run:

• dir c:\windows\system32\Recovery /a
  

Please post the outputs.

 

blue screen issue


after monthes of running system it was fine then on windows 7 it blue screened after looking it over myself and getting advice from local pc shop they suggest upgrading os will fix the issue so I upgraded to win 8.1 and along followed the blue screens now again upgrading after more advice I'm on win 10 and the bluescreens followed as a bad pool error rebooting I have included the requested report please help as spending the $150 the local pc shop wants is my next step

 

W7 Hard drive partition issue

to get rid of that 100 meg windows partition that setup creates for you on a new install on a blank hdd:

- press shift+f10 when on the partition management screen in setup <-- this opens a command prompt
- diskpart <-- start the windows command line partition management tool
- list disk <--- list the installed hdds in this computer for the next step
- select disk 0 <- might have to replace 0 with the number of the correct disk
- clean <-- this will erase all data on the disk you selected one step up- dont use the wrong disk!
- create partition primary <- creates a primary partition taking up all space on the drive, adjust the command if necessary
- exit, exit to exit diskpart and the command prompt
- click refresh in partition manager and select your newly created partition and install to that