Windows 10: Keep getting BSOD even after resetting the PC

Hey guys, I have been having this issue for a while now. I keep getting BSOD no matter what I do. I've done these steps already: - sfc /scannow - chkdsk - Windows Memory Diagnostic I even did a reset PC and even with a completely fresh windows, it keeps happening. I'm wondering whether it's hardware-related, maybe something going on with the VRAMs for my GPU. The last error I can find in the Event Manager is this: "The iocbios2 service failed to start..." The following are the dump files: https://www.dropbox.com/scl/fo/ucgyl29jnjf36jf132xgx/AM-mqwIy4E_748V2uKs-2xM?rlkey=8jhk4n51umfiwj

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Pc bsod to bios

Currently replying on iPhone, I’ll give you a proper timeline Step 1) during the program of tuneup plus my pc bsod 3 times but I was finally able to get the info Step 2) Restore point was easy and done quick which now leads to step 3 Step 3) After starting the WDV my pc bsod with the stop code of “System thread exception not handled” following the steps I open command prompt and tried to turn it off which says that nothing was changed, so then after a couple of bsod’s later I manage to go back to my restore point which now leads to a problem I cant seem to fix where when I try to open my pc it says something is wrong with my pin with error code (0x80090016) If needed I do have the tuneup plus info Trying to solve the pin problem if anyone suggestions please inform me.

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.