Windows 10: Error occurred during operation but reboot unsuccessful

I recently had a blue screen during operation which said an error had occurred and the system was gathering information for correction. After a period of time, the system attempted a reboot but failed to find a bootable file. After repeated attempts which failed, I shut down the system and did a restart without issue. This has occurred several times over the years with the same results. Is this not something that can be repaired during one of the many system upgrades?

:)

 

Error on primary Win10 Wifi Network Adaper: (Code 10) {Operation Failed} The requested operation was unsuccessful.

I am using a SurfaceBook and I am getting this error on my primary windows 10 wifi network adapter (marvell avastar wireless-ac network driver):

This device cannot start. (Code 10)

{Operation Failed}

The requested operation was unsuccessful.

This is preventing me from connecting to wifi in any way, since the driver is busted. I have tried most of the troubleshooting steps found online... namely:

• uninstalling driver and restarting
• installing driver directly from manufacturer website
• restoring windows
• updating windows
• resetting network setting
• reset entire windows image

and none of them seem to help. Can anyone help me?? right now my laptop can't connect to internet at all without an ethernet

 

when i rebuild bcd,run bcdedit /export c:\bcdbackup,An error occurred

an ERROR IS The storage export operation has failed and the system cannot find the specified FILE because when laptop startup,screen display Not connected or unable to access the required device Error code 0Xc000000e but，i run bcdedit /export d:\bcdbackup,The screen shows that the operation was successful I run these commands step by step 1.bootrec /fixmbr 2.bootrec /fixboot 3.bootsect /nt60 sys 4.bootrec /fixboot 5.bcdedit /export c:\bcdbackup 6.attrib c:\boot\bcd -h -r -s 7.ren c:\boot\bcd bcd.old 8.bootrec /rebuildbcd An error occurred in the fifth step i use diskpart and list volume Disk C is only 260M, Disk H is the system disk, Disk D is a removable disk so What command should I enter in the fifth step

 

Event ID: 51 An error was detected on device \Device\Harddisk1\DR1 during a paging operation in Windows 10.

Hi,

Welcome to Microsoft Community.

This Error event indicates that an error was detected on a physical hard disk during a disk paging operation. This problem occurs if an I/O operation to a hard disk is unsuccessful. If an I/O operation to a hard disk is unsuccessful, the Windows operating
system logs Event ID 51 in the System log.

I suggest you to refer the link below.

Information about Event ID 51

Information about Event ID 51 - Windows Server

Hope is this helps.

Regards,

Guru Kiran